No Inputs information, No LCD information

[glyn.hudson]

Hi @jsampaio

Sorry to hear your having issues. You mention that you flashed your own SD card, it looks like you have done a good job, however did the emonPi not come pre-assembled with an SD card pre-installed? Do you have you #XXX order ID number to hand, so I can verify exactly what was shipped.

@jsampaio

• What have to done additionally to have CT1 reads values?
• How to add the temperature sensor Input?
• How to add the CT2 sensor?

All sensors must be connected before powering up the unit. For the emonPi to detect the temp sensor and CT2 they must be connected before power up. Restarting the RasPi is not enough, try to fully shutdown the unit and remove the power then power up.

@jsampaio

Additionally, the LCD display is lighted on, but does not display any information, even pushing the black button.

The emonPi LCD defiantly dost not look right. It looks like a hardware issue. Could you double check the I2C LCD connections to the emonPi PCD and the contrast adjustment. After adjusting the connection you will need to restart the unit to try to reinitialize the LCD.

@jsampaio

In there any system log that can be checked regarding these symptoms?

Yes, you can check /var/log/emonpilcd/emonpilcd.log

If you are not seeing any Inputs on the Input page of Emoncms then something is not right with your hardware.