emonSD-03May16- RELEASE: HTTP Download (1.7GB) | UK Mirror 1 Canada Mirror: HTTP Download This image supports Raspberry Pi 3 and will be shipped with all emonPi’s purchased later this month (May 2016). See User Guide for user documentation. MD5 Checksum (zip): d102aff6dafd89d2e4d3209eee964251 MD…

Been fixed :thumbsup: , thanks. Should be 1880

@glyn.hudson It’s Resources - Guide | OpenEnergyMonitor > Software Resources > emonSD Pre-built SD card > EmonSD Download repository & changelog ( https://github.com/openenergymonitor/emonpi/Docs/emonSD-pre-built-SD-card-Download-&-Change-Log )

Upgraded emonpi to Pi3 and did a complete fresh install of the emonSD-03May16 release. Did a backup (before the upgrade), did the install, ran the update per the instructions, made sure everything seemed to be running (which it did), then ran the import from my backup. That went well so I copied th…

Hi I also upgraded my emonpi from RPi2 to RPi3 and switched to the emonSD-03May16 release. Restored my emonhub from the backup and my openhab configuration files from a backup copy and everything is working fine. Great Job. Thanks

Thanks, good to hear :blush: Good work setting everything up. :+1:

Hy Everybody! I’m new in the Openenergy forum, this is my first post. I need your help, and I’mnot sure that this isthe right topic to ask, so sorry in advance if I ask on a wrong topic. I bought Emon TXV2.2 board I build succesfully, & RFM69Pi 433Mhz Raspberry Pi Base Station Receiver Board. Now…

A pre-built version of the SD card can be downloaded: [image] emonSD pre built SD card Download & Change Log · openenergymonitor/emonpi... Raspberry Pi Based Energy Monitor. Hardware, Firmware & related software for the PI. - emonSD pre built SD card Download & Change Log · openenergymo…

Dear Glyn, What further steps need to make after the Sd card build, and updated as a Step 1.shows on the SD-card-build.md? After the update done do I need to proceed all the steps or few have to be skip? If yes which one need to proceed and which is don’t need? “The first thing what I did sucesfu…

It was not a big deal like I tought before,now my Emon TX board is send the Measured data to the PI and I can see on EMON CMS andon emoncms.org . Now I don’t understand why the EmonTX measure and send such a values. I connected only CT1 the current sensor and the AC adapter + DC 5vfor the board. I…

[image] hunber: rssi In telecommunications, received signal strength indicator (RSSI) is a measurement of the power present in a received radio signal.[1] In your case the wifi signal

Community

OpenEnergyMonitor

Home
Docs
Community
Shop
Search

OpenEnergyMonitor Community

emonSD-03May16 Release

emonSD

show post in topic

Home
Categories
Guidelines
Terms of Service

Powered by Discourse, best viewed with JavaScript enabled