emonPi WiFi Config : Status - Disconnected

[dmdrewitt (David Drewitt)]

Hi Trystan

I have run the command and get the following results.

wlan0     IEEE 802.11  ESSID:"Correct name"  
          Mode:Managed  Frequency:2.462 GHz  Access Point: 44:4E:6D:D7:1B:A1   
          Bit Rate=65 Mb/s   Tx-Power=31 dBm   
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Power Management:on
          Link Quality=42/70  Signal level=-68 dBm  
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:8  Invalid misc:0   Missed beacon:0

[Mod - edited for readability, for “code” formatting info please see FAQ’s]

@Bill.Thomson

When posting code or output, please put 3 ‘backticks’ (normally found at the top left of your keyboard) on a line of their own before the code, and 3 more backticks also on a line of their own after the code. The result should look similar to this:

code

If your post contains text that is a language, e.g. php, you can add a language identifier
after the first 3 backticks like this: ```php

If you don’t want any markup language applied, you can add the word text, like this: ```text