diyBMS 4 - How to change network my BMS is connected to?

I have setup diyBMS on my bench and connected to the house wifi. Now I want to move it to its final destination and need to change the network.

I’ve looked through its web page but can’t find anything. How do I do that?



I also wish the webui had this change option as well ,
I have been Erasing then re-flashing mine

would be nice if it had Standalone AP mode option and not need to connect to a 3rd party wifi , I had to run a cat5 cable 50m and put in a wifi router in the garden shed where batteries live

Same doubt…is this question answered somewhere? :slight_smile:

It has been a while but if I remember correctly you can change the network by connecting a serial terminal.