I put together an energy monitoring system in 2014 to monitor my solar production. It worked well but after a few years the Raspberry Pi board that I used with it died. I still have an EmonTX Arduino Shield, an EmonTH and an EmonTX stand alone board. I also have three RFM12B to Raspberry Pi board…

Hello @TomT I think this firmware available from the Emoncms update tool might work: [image] The older firmware’s are also available here: //github.com/openenergymonitor/RFM2Pi/tree/master/firmware/old

Thanks Trystan. I’ve downloaded and installed the firmware for the EmonTX and the Arduino shield. It took me a bit to find the #define for the Rfm69 and turn it off so my , but it looks like they’re working now. At least the serial monitor is throwing out valid data. I’ve downloaded the SD card …

Hi Trystan, I downloaded version emonSD-01Feb24 and it seemed to start successfully. Once it was up and running I updated everything using the Full Update button just to be sure. I have not been able to update the firmware on the rfm12 board. It doesn’t seem to be able to communicate via the ser…

A bit late, but this : [image] Emonsd Feb24 - ttyAMA0 used by kernel causing interference with RFM / emonhub emonSD Great. I’ve added a link above for the PR to fix emonPiLCD1.py If you’re in a merging mood, can you also look at this long overdue PR (you asked me to resu…

I still haven’t been able to program the rfm12 board via the Raspberry Pi. However I think that the firmware that I had in place was viable. I’ve been able to get a bit further. I also found that through experimentation what should and shouldn’t stay in the config file with my old hardware and no…

Old Open Energy Monitor hardware with Raspberry Pi 4

Hardware

alandpearson (Alandpearson) 11 May 2024 14:07 5

A bit late, but this :