# WD Curve scheduling Daikin Altherma **URL:** \ **Category:** Emoncms\ **Created:** [11 November 2023 10:39 UTC](https://community.openenergymonitor.org/t/wd-curve-scheduling-daikin-altherma/24744 "2023-11-11T10:39:57Z")\ **Posts on this page:** 1\ **Showing post:** 26
**Author:** ![Stephen\_Crown](https://community.openenergymonitor.org/user_avatar/community.openenergymonitor.org/stephen_crown/32/26680_2.png) [@Stephen\_Crown](https://community.openenergymonitor.org/u/Stephen_Crown)\ **Post date:** [12 December 2024 14:07 UTC](https://community.openenergymonitor.org/t/wd-curve-scheduling-daikin-altherma/24744/26 "2024-12-12T14:07:49Z")
@tiger_cook `Antifrost` is definitely disabled on my setup, and I found it by trying to understand exactly what you’re going through now. If you disable that setting, at 6C or below you will still see `Sampling` however at `60% pump speed` periodically per your previous posts even if Space Heating is set to `Off` - that should be considered normal and the best you can do in `LWT` mode. Unsure if you have the same issue that a few of us have resolved on the bigger units where tape heaters were always on when the pump ran (even above 6C!) - I shaved ~80watts (50%) off the power usage during sampling by fixing this issue that is for some reason the jumper cable is in place (incorrectly) for U.K. Daikin units. > [@Daikin Altherma, ESPAltherma & Home Assistant with OpenEnergyMonitor](https://community.openenergymonitor.org/t/daikin-altherma-espaltherma-home-assistant-with-openenergymonitor/25057/88): > > I had a visit from a Daikin engineer today. He installed new firmware on the outside unit that is supposed to help the response time of the expansion valve. I also reported my concerns about the inlet water tape heater that I mentioned here: The engineer has fixed the wiring for that. It sounds like some jumper or connection was set incorrectly. I disconnected ESPAltherma before the engineer visit, so as not to freak him out. smile I’ll reinstall it over the weekend and see if I get clos… --- _[View the full topic](https://community.openenergymonitor.org/t/wd-curve-scheduling-daikin-altherma/24744)._