# Simple Housing for the RJ45 extender (3d printer reqd)

**URL:** <https://community.openenergymonitor.org/t/simple-housing-for-the-rj45-extender-3d-printer-reqd/7273>\
**Category:** Hardware\
**Created:** [25 April 2018 10:38 UTC](https://community.openenergymonitor.org/t/simple-housing-for-the-rj45-extender-3d-printer-reqd/7273 "2018-04-25T10:38:55Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![bazzalight](https://community.openenergymonitor.org/letter_avatar_proxy/v4/letter/b/85f322/32.png) [@bazzalight](https://community.openenergymonitor.org/u/bazzalight)\
**Post date:** [25 April 2018 10:38 UTC](https://community.openenergymonitor.org/t/simple-housing-for-the-rj45-extender-3d-printer-reqd/7273/1 "2018-04-25T10:38:55Z")

</div>

I have created a simple box for the 4 port RJ45 extender for those with a 3d printer. Design is available on thingiverse at [Housing for RJ45 splitter used for EMON Pi by bazza\_light - Thingiverse](https://www.thingiverse.com/thing:2878060). Board is just a push fit into the box but it will protect from accidental shorts to the PCB.