Graphs display Volt values as Watts while IotaWatt Power Monitor displays everything ok

Sauli · 2021-06-07T15:02:35.639Z

This is a new IotaWatt installation Firmware version: 02_06_02, with six current measurement for two three phase systems and one voltage measurement. The nominal voltage between phases and the zero in the wye (Y) type system is 230V. The first of the systems measures currents for the whole site and the other system measures the currents for the carage only.

In the IotaWatt Power Monitor all the power consumptions and the voltage values seem to be ok but on the graphic visualizations (Graph+ and the Original Graph) the values for the power in Watts of the first system seem to display voltage values. I.e. it is all the time between 230 and 239. The Volt and Watt values are identical also in the CSV list.
The Watts for the second system seem to be ok in the graphic visualization.

Any ideas how to fix this?

Robert.Wall · 2021-06-07T15:08:07.422Z

I suggest The IoTaWatt forum is a better place to ask a question that is specifically about the operation and use of IoTaWatt. That is managed by Bob Lemaire, its creator, and he and the other users there are more likely to have the specific knowledge to help you.

The IoTaWatt forum uses the same software as this forum, but you must register a new account there. If the user name you have here is not taken, it might be helpful to have the same user name in both places.

If you post your question there, I’m sure he or somebody will get back to you quickly.

Sauli · 2021-06-09T03:58:12.986Z

Thanks. Got the answer there.
The problem was in duplicate naming of the sensor inputs in settings.