EmonTx 3.2.1 with PLL diversion stop working after upload

1111 · 2018-07-12T11:10:16.902Z

Hi,
I have EmonTx V3.2.1(according to PCB) that works without any problem since the beginning of 2015. Recently I decided to do some modifications over constants into the beginning of the sketch. The sketch is from here
https://learn.openenergymonitor.org/pv-diversion/pll/files/emonTx_Solar_Controller_Temperature_PLL_0.zip
After upload with Arduino IDE(under Linux and Windows - the same result) and USB to UART device purchased with EmonTx, the device stoped working, red LED lights continuously. I tried to power it with 9V AC/AC converter that I have used since the beginning, and the result was LED blinking approximately two times per second and did not work at all.
I spend almost a week researching into archived forum as well here without any result. Final attempt was with PlatformIO, and the result is the same again. With PlatformIO I did the serial test but there was not any result on the screen.
I am not expert, because I am rather mechanical engineer than electrical one, and I have some experience with Arduino IDE at 2015 during initial programming with the same sketch, but since then I did nothing, and everything was in perfect working condition without any problem.
What is wrong?
Please help.

Robert.Wall · 2018-07-12T20:08:17.684Z

What did you change?
That sketch was originally written for the emonTx V2, therefore unless you have changed the I/O pins, they are wrong for your emonTx V3.2.
You must have changed those in 2015 to make the sketch work then.

This might help (change the name to emonTx IO-all.html)
emonTx IO-all.html.txt (6.1 KB)

From memory, I do not think there are any other changes you must make, but my emonTx V3.2 is being used for a long-term test, so I cannot run a test for you. But if what I have already written does not solve the problem, post again.

1111 · 2018-07-13T13:31:49.147Z

Yes,
That was exactly what I need. Thank you very much! The device is already programmed, and everything looks normal. After mounting into the isolated box, I will inform you additionally.