atanisoft
(Mike Dunston)
23 March 2021 19:17
3478
the new controller has four on-board relays, two blue ones (top left area of your PCB pic) which have three screw terminals (NC, COM, NO) and then there are two smaller black ones on the bottom left side of the PCB picture that are like a traditional switch (open or closed circuit).
You would need to add a number of jumpers to use the existing relay board on the new controller likely. It would likely be easier to extend the relay wires to the new controller board instead.
stuart
(stuart)
23 March 2021 19:33
3479
There is only 1 led now, it’s blue because it’s cheaper than green from jlcpcb!!
2 Likes
stuart
(stuart)
Split this topic
25 March 2021 09:55
3481
stuart
(stuart)
Split this topic
25 March 2021 09:56
3484
6 posts were split to a new topic: External 47K NTC thermistor
stuart
(stuart)
Split this topic
25 March 2021 09:57
3487
stuart
(stuart)
Split this topic
25 March 2021 09:54
3492
5 posts were split to a new topic: AVRDUDE “B” parameter
stuart
(stuart)
Split this topic
25 March 2021 09:50
3496
3 posts were split to a new topic: Relay not triggering
stuart
(stuart)
Split this topic
25 March 2021 09:53
3501
stuart
(stuart)
Split this topic
25 March 2021 15:33
3507
voltmeter
(voltmeter)
25 March 2021 17:58
3510
got my esp32 devkitc from china
it seems i am very unlucky this one does not work too
no modules found no testcode work
have tryed new firmware(25) and from other computer
i made a putty screenshot on testcode
atanisoft
(Mike Dunston)
25 March 2021 18:01
3511
That output looks like it is reporting an invalid application image. Perhaps try and erase the flash and try again?
voltmeter
(voltmeter)
25 March 2021 18:10
3512
disconnected again from pcb and flashed test code
same putty output - invalid header
i dont know what else to do
this is crazy
have ordered 2 new esp from other seller, this is insane.
stuart
(stuart)
25 March 2021 21:34
3513
Just to be safe, try flashing one of the older releases, just in case a problem has crept into the new build process on GitHub.
voltmeter
(voltmeter)
25 March 2021 21:54
3514
where can i get the oldest controller test file for flashing with node mcu flasher?
stuart
(stuart)
25 March 2021 22:10
3515
They are all on GitHub, in the release section
voltmeter
(voltmeter)
25 March 2021 22:14
3516
the controller test file is only available since 3-17 release
Fred7421
(Fred Moffatt)
25 March 2021 23:15
3517
Hey Stuart, there are lcd touch panel displays available with an sd card slot on them, will that work if I just remove the card slot on the board?
stuart
(stuart)
25 March 2021 23:25
3518
No need to remove the card slot on the board, just don’t use both at the same time