# Diybms - poor cell modules communication SOLVED

**URL:** <https://community.openenergymonitor.org/t/diybms-poor-cell-modules-communication-solved/20525>\
**Category:** diyBMS\
**Created:** [19 May 2022 19:20 UTC](https://community.openenergymonitor.org/t/diybms-poor-cell-modules-communication-solved/20525 "2022-05-19T19:20:39Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![artypete](https://community.openenergymonitor.org/letter_avatar_proxy/v4/letter/a/bb73d2/32.png) [@artypete](https://community.openenergymonitor.org/u/artypete)\
**Post date:** [19 May 2022 19:20 UTC](https://community.openenergymonitor.org/t/diybms-poor-cell-modules-communication-solved/20525/1 "2022-05-19T19:20:39Z")

</div>

I’ve had a lot of trouble with constant dropouts of cell module communication, I believe it’s my noisy inverter messing things up badly.

I notice communication is fine if inverter not running.

So I went back to basics and simply grabbed both the rx and tx lines, and controller starts picking up the modules right away!  
Thinking I must be grounding the noise signals, I’ve next tried putting some aluminium tape over the rx and tx lines and connecting that to battery negative. Seems to be working well 😊

(Basically I’ve just made diy screened cable! 😂)

Hope this helps people with cell coms issues?
